Shader: "wrapped brick bonds"
"wrapped brick bonds"

ClassColour
Synopsis An extended wrapped brick pattern, with pre-defined standard bond patterns.
Arguments

"scale" Description: Overall scaling factor; increasing this value will make the pattern appear larger.
Default:1.0
Hint:[ 0.01, 1000 ]
"brick width" Description: The width of the bricks.
Default:1.0
Hint:-
"brick height" Description: The height of the bricks.
Default:0.5
Hint:-
"brick depth" Description: The depth of the bricks.
Default:0.7
Hint:-
"mortar size" Description: The amount of mortar between the bricks.
Default:0.1
Hint:-
"brick side colour 1" Description: One extreme of the range of colours to be used for the side of the bricks.
Default:(0.9, 0.4, 0.1)
Hint:-
"brick side colour 2" Description: The other extreme of the range of colours to be used for the side of the bricks.
Default:(0.7, 0.35, 0.05)
Hint:-
"brick end colour 1" Description: One extreme of the range of colours to be used for the end of the bricks.
Default:(0.5, 0.25, 0.0)
Hint:-
"brick end colour 2" Description: The other extreme of the range of colours to be used for the end of the bricks.
Default:(0.35, 0.18, 0.0)
Hint:-
"mortar colour" Description: The colour of the mortar between the bricks.
Default:(0.3, 0.3, 0.3)
Hint:-
"rough scale" Description: Determines the complexity of the roughness along the brick edges; values less than 1.0 produce a rougher appearance, and values greater than 1.0 a smoother appearance.
Default:1.0
Hint:-
"rough amplitude" Description: Determines the magnitude of the roughness along the brick edges, with values less than 1.0 corresponding to small variations, and values greater than 1.0 large variations.
Default:1.0
Hint:-
"fuzz" Description: Controls the amount of blurring of the edge of the bricks. 0.0 means no fuzz---edges are razor sharp. 1.0 gives maximal blurring---the blurred area width is equal to the half of the square size. Note: Will only have an effect if Analytic Anti-aliasing (Lightworks Advanced Rendering) is available.
Default:0.5
Hint:-
"bond" Description: Select standard bond type (pattern): 'Stretcher' (standard alternating pattern), 'Common' (bricks in every fifth row stacked crosswise), 'Flemish' (bricks placed crosswise alternately with normal in each row), 'English' (as 'Common', but with crosswise bricks every second row), 'Stack' (bricks are stacked directly on top of each other), 'Rowlock' (as 'Flemish' but bricks are placed on their sides).
Default:LI_BOND_STRETCHER
Hint:-

Previous page alphabetically (wrappedbrick)
Next page alphabetically (wrappedbrickbondsdisplacement)
Index


Copyright © 2010 Lightwork Design Limited. All rights reserved